NEWS

Contact

Road shot blaster for marking line

Sometimes road markings are need to cleared such as changes in traffic management schemes. If the marking line not be cleaned, it is easy to cause misleading by the driver. This is very unfavorable for safety and traffic control, so how to clean the road marking line become very important. The friction coefficient of the marked line surface cleaned by the road shot blaster is improved, which is beneficial to driving safety . The equipment is equipped with a filter cartridge dust collector, so no dust is generated during the cleaning operation. The road shot blaster is especially suitable for the sidewalk on the urban road, highway road , airport runway ect.

Road shot blaster for marking line

The features of road shot blaster:

1. No pollution .During the whole construction process, and achieve environmental protection construction . The road shot blaster is a non-contact cleaning. In the initial stage of the shot blasting machine, the worker should open the travel switch of the shot blasting machine firstly. The equipment is equipped with a dust collector. The seals and wear parts must be inspected daily. If found the wear parts are damage should be replaced immediately. It also can Recycle dust purification treatment.

2. Less investment. After the funds are invested, the epoxy mortar putty is sealed and smoothed or repaired. It is about one-tenth of traditional investment.

3. High efficiency. It can clean 260 square meters per hour, above SA2.5. As usage time gets longer and longer, there is more and more experience.

4. High degree of automation. The equipment can be climbed and walked, and the used pellets can be recycled.

5. Mobile is more convenient. The equipment can mobile, the design is reasonable and compact, and it covers a large amount of scattered dust, which can be brought to the construction site at any time.

Road shot blaster for marking line 2

NEWS

Contact